We gotta have lights now that we’ve installed a new window to show off our components. Lights are one of the most inexpensive case mods, but have a high visual impact, especially if you are running an intricate water-cooling setup with UV dye. These are by far the best bang for the buck kits that I have used. Very simple installs and multiple mounting positions for the best look of what you are looking for.
End ends are capped so the cathode tube doesn’t fall out of the protective plexiglass casing, and the inverter comes with Velcro for easy and creative mounting nearly anywhere in your case. Power is supplied by a standard 4-pin molex connector and the power leads are of adequate length for even a huge case like the Lian Li V-2000
The install on the CCFL’s is quite easy, other than the pci switch that Is mounted to in the rear open pci bracket slot. Personally I remove the swithch from the bracket and put it in the lowerportion of the case. Where this does give you the option to keep the slots open for other more important hardware. Mounting on the tubes themselves is simple and easy. They come with strips of Velcro to.
 |
 |
 |
|||
|
|
|
|||
 |
|
 |
And I did add a little bit of color to the mix with another Logisys 12 and 4 inch kit, only in cold blue, which does add the “hey look at me” effect to the mix.
